Kichler 12383 User Manual download pdf

KICHLER 30 WATT (P/N: 12383WH, BK)

AND 60 WATT (P/N: 12384WH, BK) WALL PLUG

POWER SUPPLY INSTALLATION INSTRUCTIONS

Before Installing:

All installations should comply with National and local electrical

codes.

If you have any doubts concerning installation contact a qualiﬁed,

licensed electrician.

1) For use only with Kichler

LED 24VDC Class 2, 5 AMP MAX

Cabinet Lighting ﬁxtures and Accessories.

2) Plug power supply into outlet and run the 4ft cable to the location

of where the ﬁrst ﬁxture is to be connected. Hold the power

cable to mounting surface and determine best path for cable. If

the cable is being run from cabinet to cabinet a notch such as

a “V” could be cut in cabinet side panels to help keep cable out

of sight. (See ﬁg. 3)

NOTE: Interconnect cable is UL rated CL2. Installer should

check with local building codes to determine if CL2 wire is

allowed to run through walls and ceilings.

3) Determine desired location of ﬁrst ﬁxture to be connected.

Mounting surface should be a minimum of ½” thick and

approximately 2” clearance for interconnect and power cable

should be allowed at both ends of ﬁxture. For LED ﬁxture

installation instructions refer to ﬁxture instruction sheet supplied

with product.

4) Connect polarity sensitive plug from the 30 watt P/N 12383 or

60 watt P/N 12384 power supply to the ﬁxture.

NOTE: The male connector attached to the 30 and 60 watt

power supply will connect to the corresponding female

connector of a ﬁxture, module or interconnect cable. If

connecting to another male connector is required, you must

use Kichler

Gender Adaptor (Kichler P/N: 12348WH, BK

included). An additional 2” will be needed on the side of the

ﬁxture to clear the extra length of the gender changer.

5) Peel backing off retaining clip(s) and afﬁx to desired location(s).

Surface should be as clean as possible. Drive pre-installed

screw into the cabinet surface to secure the retaining clip to the

surface. (See ﬁg. 4)

6) Slip Cable into clip(s) and snap closed

Date Issued: 10/12/07 IS-12383-CB

CONNECTING POWER SUPPLY

TO GENDER CHANGER

TO FIXUTRE

Retaining Clip

Backing

Fig. 3

Cabinet Side Panel

Fig. 4

CONNECTING POWER SUPPLY

TO FIXUTRE

INSTRUCTIONS

For Assembling and Installing Fixtures in Canada

Pour L’assemblage et L’installation Au Canada

Summary of Contents

Page 1

KICHLER 30 WATT (P/N: 12383WH, BK) AND 60 WATT (P/N: 12384WH, BK) WALL PLUGPOWER SUPPLY INSTALLATION INSTRUCTIONSBefore Installing:All installations s

Comments to this Manuals

No comments

Kichler 12383 User Manual

Browse online or download User Manual for Hardware Kichler 12383. Kichler 12383 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Kichler 12383