Kichler 15426 User Manual download pdf

SAFETY INSTRUCTIONS

READ THIS FIRST

KEEP THESE INSTRUCTIONS

This ﬁxture is intended for installation in accordance with the National

Electric Code (NEC) and Local code speciﬁcations. Failure to adhere to

these codes and instructions may result in serious injury and/or property

damage and will void the warranty.

1) WARNING: This ﬁxture is not to be installed within 10 feet (3M) of a pool,

spa or fountain.

2) This ﬁxture is to be used only with a power unit (transformer) rated a

maximum of 300 W (25 AMPS) 15 volts.

3) The #18 ga. ﬁxture wire is not intended for direct burial.

4) Direct burial rated wire is to be buried a minimum of 6” (152mm) beneath

the surface of the ground.

NOTE: If additional Direct Burial wire is needed, contact your local Kichler

landscape distributor.

 •8GAwirecanbepurchasedinlengthof250’(76M),15503-BK.

 •10GAwirecanbepurchasedinlengthof250’(76M),15504-BK.

 •12GAwirecanbepurchasedinlengthsof100’(30M),15501-BK;250’

  (76M),15502-BK;500’(152M),15505-BK;and1000’(304M),15506-BK.

5) Fixture shall not use a tungsten halogen lamp unless the ﬁxture is marked

for use with such lamps.

6) Wiring connections must be made with approved/listed wire connection

 device(s)suitablefortheapplication.Donotexceedmanufacturers’wiring

combination speciﬁcations for size and quantity of conductors.

ASSEMBLY AND INSTALLATION

1) Determine desired location for mounting ﬁxture.

2) At desired location, hammer stake (A) into ground. To avoid damage to

stake, place a board on top of stake while hammering. If ground is hard

and stake is difﬁcult to install, make a crosscut in ground using a ﬂat shovel.

3) Clear away area in ground at wireway slot (B) in top of stake (A).

4) Lay 12V cable into wireway slot (B) and screw stem (D) into stake (A). If

assembly does not look straight, adjust by pushing or pulling on stake only.

5) Install provided lamp into socket (E) inside ﬁxture head (F).

6) Setcage(H)overglass(G).

7) Raiseglasswithcageuptoxturehead,passingholeinglassoverbulb

and socket.

8) Screw socket ring (J) onto socket (E) to secure glass in place.

9) TURNOFFPOWER.

10) Make wire connections using supplied Quic Disc

™

following instructions

below, or using other approved wiring connection method (not supplied.)

WARRANTY

WE WARRANT THE LANDSCAPE PRODUCTS FEATURED IN OUR LANDSCAPE LIGHTING CATALOG (WITH THE EXCEPTION OF LIGHT BULBS) FOR FIVE YEARS AGAINST DEFECTS IN

MATERIALS AND WORKMANSHIP IF IT WAS PROPERLY INSTALLED AND FAILED UNDER NORMAL OPERATING CONDITIONS, PROVIDED IT IS RETURNED TO THE POINT OF PURCHASE,

WHERE IT WILL BE REPAIRED OR, AS IT MAY BE DETERMINED, TO REPLACE THE LANDSCAPE PRODUCT OR PARTS USED ON THAT PRODUCT.

DateIssued:5/7/10 IS-15426-US

Quic Disc

™

WIRING INSTRUCTIONS

Turn off power.

Thefulllengthofthe18GAxturewiremaybeusedtoconnectwiththe10GAor12GAcableprovidedthefollowingconditionsaremet:

•Wiringistobeprotectedbyroutingclosetothextureoraccessoryorsecuredtoabuildingstructuresuchashouseordeck.

• 18GAxturewiringistobecutoffsothatitisattachedtotheconnectorwithin6inchesofthextureorbuildingstructure.

• Ifitisnecessarytomaketheconnectionsunderground,thennomorethan6inchesofthe18GAxturewireistobeburied.

The Quic Disc

™

connector is designed to install one ﬁxture and accommodates one18GAxturewireandone10GAorone12GAsupplywire.

Placethe10gaugesupplywireacrosstheareamarked10GAonQuicDisc

™

orplacethe12gaugesupplywireacrosstheareamarked12GA

on Quic Disc

™

Placethe18gaugexturewireacrosstheareamarked18GAontheQuicDisc

™

. After the wires are in place, connecta the top of the Quic

Disc

™

to the base with supplied screw, making sure that the wires remain ﬂat in the bottom portion of the Quic Disc

™

, and the screw is tightened

all the way down.

Thecoppercontactswillautomaticallypiercethewires’insulation.Excess18GAxturewirethatsticksouttheendoftheQuicDisc

™

is to be cut off.

Makenootherwiringconnectionstothe18GAxturewire.

1 2

SAFETY INSTRUCTIONS 1

Summary of Contents

Page 1 - SAFETY INSTRUCTIONS

SAFETY INSTRUCTIONSREAD THIS FIRSTKEEP THESE INSTRUCTIONSThis ﬁxture is intended for installation in accordance with the National Electric Code (NEC)

Page 2

INSTRUCCIONES DE SEGURIDADPRIMERO LEA ESTOGUARDE ESTAS INSTRUCCIONESEste artefacto se debe instalar de acuerdo con el Código Eléctrico Nacional (NEC,

Kichler 15426 User Manual

Browse online or download User Manual for Lighting Kichler 15426. Kichler 15426 User Manual

Summary of Contents

Related models: 15326 | 15315 |

More documents for Lighting Kichler 15426

Comments to this Manuals

Kichler 15426 User Manual

Browse online or download User Manual for Lighting Kichler 15426. Kichler 15426 User Manual

Summary of Contents

Related models: 15326 | 15315 |

More documents for Lighting Kichler 15426

Comments to this Manuals

Related products and manuals for Lighting Kichler 15426